Icom IC-F3062T - 3 Basic Operation; Turning Power on

11
3
BASIC OPERATION
2
3
Turning power ON
■
Prior to using the transceiver for the first time, the battery
pack must be fully charged for optimum life and operation.
((☞ p. 30))
Rotate [VOL] to turn the power ON. q
If the transceiver is programmed for a start up password, w
input the digit codes as directed by your dealer.
• 10-keypad can be used for password input depending on ver-
sion:
• The keys in the table below can be used for password input:
• The transceiver detects numbers in the same block as identical.
Therefore “01234” and “56789” are the same.
KEY
NUMBER
0
5
4
9
3
8
2
7
1
6
(Side3)
When the “PASSWORD” indication does not clear after in- e
putting 4 digits, the input code number may be incorrect.
Turn the power off and start over in this case.
Battery type selection
D
The battery type must be selected according to the attaching
battery type when tuning the transceiver ON.
While pushing and holding [Emer] and [PTT], rotate [VOL] ➥
to toggle the attaching battery type.
• After the display appears, release [Emer] and [PTT].
• “ DRY BATT” is displayed for about 3 sec. then “Lo” appears when
the battery case operation is selected.
• “LI-ION” is displayed for about 3 sec. when the Lithium-ion bat-
tery operation is selected.
• This operation may not be available depending on the pre-setting.
Ask your dealer for details.