Icom IC-F3062T - D Group Call; D Displaying the Received Call Record

Group call
D
When a group call is received; q
• Beeps sound.
• “ ” appears and the mute is released.
• The programmed text message (e.g.“GROUP”) and the calling
station ID (or text) is displayed when the indication mode is 2
lines.
• The programmed text message (e.g.“GROUP”) and the calling
station ID (or text) is displayed alternately when the indication
mode is 1 line, depending on the setting.
• “ ” appears or blinks depending on the setting.
GROUP
1120
TXCECALL BIFN TXC
Appears Appears or
blinks
Push and hold [PTT], then speak into the microphone at a w
normal voice level.
• TX indicator lights red.
NOTE: Only one station is permitted to speak.
Release [PTT] to return to receive. e
• BUSY indicator lights green while receiving a signal.
To finish the conversation, push [Moni(Audi)] to send the r
‘Clear down’ signal.
• Either station can send a ‘Clear down’ signal.
• “CLR DOWN” is displayed for 2 sec. (approx.)
• “ ” disappears and the transceiver returns to the standby condi-
tion.
Displaying the received call record
D
— Queue indication
The transceiver memorizes the calling station ID in the mem-
ory. Up to 3 calls can be memorized, and the oldest call re-
cord is erased when a 4th call is received. However, once the
transceiver is powered OFF, the all records are cleared.
Push and hold [Digital Button] for 1 sec. q
• Displays following indication.
When a record is available
< QUEUE >
–QUEUE!–
TXCECALL TXC BIFN
When no record is available
< QUEUE >
NO QUEUE
TXCECALL TXC BIFN
Push [CH Up] or [CH Down] to select the desired call. w
Push and hold [Digital Button] for 1 sec. again to return to e
the standby condition.
• When no operation is performed for 30 sec., the transceiver re-
turns to the standby condition automatically.
18
4
BIIS OPERATION