Icom IC-F3062T - Position Data Transmission

25
4
BIIS OPERATION
4
• Available characters
Key Characters
[0]
[1]
[2]
[3]
[4]
[5]
[6]
[7]
[8]
[9]
(space)
0][!|’”,?:_()<>;
2BAabcC
3EDdefF
4HGghiI
5KJ jklL
6NMmnoO
7QPSpqrsR
9XWZwx yzY
8UTtuvV
1^@#
M
/–=\&%$+
NOTE: A decimal point can only be written with the CS-
F3060
c l o n i n g s o f t w a r e . Pre-programmed characters
can be rewritten with the 10-keypad, except for the deci-
mal point, as it is not included in the transceiver character
list, and cannot be displayed again.
Position data transmission
■
When the optional cable (OPC-966) and a GPS receiver is
connected to the transceiver, the position (longitude and lati-
tude) data can be transmitted automatically.
Ask your dealer or system operator for connection details.
The position data is transmitted when;
• Status 24 message is received
*When the status 24 message, GPS request, is received.
• Fully automatic
When automatic position transmission is enabled, send
the position data according to ‘Time Marker’ and ‘Interval
Timer’ settings.
• PTT is released
When ‘Send with Logoff’ is enabled.
- Set the ‘Log-In/Off’ item as ‘L-OFF.’
• After sending a status message
When ‘Send with Status’ is enabled.
• After sending an SDM
When ‘Send with SDM’ is enabled.
• After sending status 22 (Emergency)
When ‘Send with Emergency’ is enabled.