Icom IC-M127 - Call Channel Programming

BASIC OPERATION 3
@ Call channel programming SB Reh [6] gai program An fas
displayed channel as the call aa: Pa
The call channel switch, [9], is used to select channel 9, how- channel.
ever,
you
can
program
your
most
often-used
channels
in
each
*The
call
channel
number
and
channel group for quick recall. channel group stop flashing.
@ Push [CH/WX * U/I/C] for 1 sec. 1
one
or
more
times
to
select
uy
i
i
j
the
desired
channel
group
ie
Ma
Display
backlighting
(USA,
INT,
CAN)
to
be
pro-
—_______J
The
function
display
and
switches
can
be
backlit
for
better
vis-
grammed. ibility under low light conditions.
@ Push [9] to select the call PPro ;
channel of the selected chan- usa LY. While pushing [HI/LO * DIM], rotate the channel selector or
nel group. use [UPJ[DN] switches on the microphone to adjust the back-
*“CALL’ and the call channel num- lighting.
ber appear. | ‘* Backlighting can be set to 1 of 7 intensities or turned OFF.
@ While pushing [HI/LO] push [9] Se
to enter call channel write
mode.
*
Call
channel
number
and
chan-
DIMMER
7
DIMMER
OFF
nel group to be programmed flash. Backlighting set to brightest Backlighting turned OFF
@ Rotate the channel selector to a a
select the desired channel. cat
= CUA
ad 1 N
aS See |