Icom IC-M200 - Dualwatch and Tri-watch; Simultaneous Channel Monitoring

11
5
DUALWATCH/TRI-WATCH
Dualwatch and Tri-watch are convenient to monitor
Channel 16 while you are operating on another
channel.
NOTE: Select Dualwatch or Tri-watch in the Set
mode. (p. 13)
1. Select the desired channel.
2. Push [DW] to start Dualwatch or Tri-watch.
• “DW” blinks during Dualwatch. “TW” blinks during Tri-
watch.
• A beep sounds when a signal is received on Channel 16.
3. Push [DUAL] (SCAN) again to cancel Dualwatch
or Tri-watch.
DUALWATCH/TRI-WATCH SIMULATION
Dualwatch
Tri-watch
Monitors Channel 16
while receiving on
another channel.
(example: CH 88A)
Monitors Channel 16 and the
Call channel while receiving on
another channel.
(example: CH 88A)
Call channel
When a signal is received on:
• Channel 16: Dualwatch/Tri-watch pauses on Channel
16 until the signal disappears.
• On the Call channel:
Tri-watch switches to Dualwatch until the
signal on the Call channel disappears.
[Example]:Tri-watch on INT channel 25
2. Signal is received on the
Call channel.
to start Tri-watch.
3. A signal is received on
Channel 16 takes priority.
4. Tri-watch resumes after
the signal disappears.
1. Push