5
6
12
16
15
14
13
12
11
10
9
8
7
4
3
2
1
SET MODE
6
■ Set mode
In the Set mode, you can change the settings of the
transceiver’s functions.
NOTE: Available functions may differ depending on
the dealer setting. Ask your dealer for details.
D Set mode operation
1. Turn OFF the transceiver.
2. While holding down [16/C], turn ON the
transceiver.
• Enters the Set mode.
• “SCAN” is displayed.
3. Push [16/C] several times until your desired item is
selected.
4. Push [▲] or [▼] to change the setting.
5. Turn OFF the transceiver, then ON again to exit
the Set mode.
D Set mode sequence
• Key Beep
• Scan type • Scan resume timer
• Dual/Tri-watch
• FAV on MIC
Scrolls
Starts with this item
Push
To Next Page
Loading...
