Icom IC-M35

D SET MODE ITEMS (The display shows the current settings, and the selected item is displayed in the dotted circle.)
17
7
SET MODE
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
• Auto scan
†
Starting item
• Beep tone
• Lo
w fix*
• Scan resume timer
†
• Dual/Tri-watch
†
• Automatic
backlighting
• Power save
• LCD contrast
• Monitor key action
• Squelch sensitivity
• Priority scan
†
• Noise detection
: Push +
: Push or +
*Appears only when the optional
battery case is attached; not
available with German version
depending on the pre-setting.
†
Not available with Holland version.
■ Set mode programming
Set mode is used to change the conditions of transceiver’s
functions: Beep tone function, Priority scan function
†
, Scan
resume timer
†
, Auto scan function
†
, Dual/Tri-watch function
†
,
Monitor key action, Automatic backlighting, LCD contrast
setting, Power save function, Squelch sensitivity, Low fix
function* and Noise detection function.
* Appears only when the optional battery case is attached; not avail-
able with German version depending on the pre-setting.
†
Not available with Holland version.
D Set mode operation
q Turn power OFF.
w While pushing [VOL/SQL MONI], turn power ON to enter
the set mode.
• “bP” appears.
e Push [VOL/SQL MONI], or push [Y]/[Z] while pushing
and holding [VOL/SQL MONI] to select the desired item.
r Push [Y]/[Z] to select the desired condition of the item.
t To exit the set mode, push [16 C].