[Example]:
Operating dualwatch on INT
Ch 25
Operating tri-watch on INT
Ch 25
3
BASIC OPERATION
8
■ Description
Dualwatch monitors Ch 16 while you are receiving an-other
channel; tri-watch monitors Ch 16 and the call channel while
receiving another channel.
DUALWATCH/TRI-WATCH SIMULATION
•If a signal is received on Channel 16, dualwatch/tri-watch pauses
on Ch 16 until the signal disappears.
•If a signal is received on the call channel during tri-watch, tri-watch
becomes dualwatch until the signal disappears.
•To transmit on the selected channel during dualwatch/tri-watch, push
and hold [PTT].
■ Operation
q Select the desired operating channel.
w Select dualwatch or tri-watch in set mode. (p. 20)
e Push [CH/WX] for 1 sec. to start dualwatch or tri-watch.
•“DW” appears during dualwatch; “TW” appears during tri-watch.
• Beep tone sounds when a signal is received on Channel 16.
r To cancel dualwatch/tri-watch, push [CH/WX] again.
To Next Page
Loading...
