Icom IC-M402

16
6
DSC OPERATION
■ DSC individual ID
A total of 30 DSC address ID’s can be programmed and
named with up to 10 characters.
ïï
Programming address ID
q Push [DSC] to select the DSC menu.
w Push [Y]/[Z] to select “ADDRESS”
and push [DSC].
e Push [Y]/[Z] to select “ADD” and
push [DSC].
r Set the distress ID and ID name, then
push [DSC].
•Rotate the channel selector to select the
character.
• Push [H/L] to advance the cursor.
•Push [CH/WX] to move the cursor back-
ward.
• Push [16] to cancel and exit the condition.
•Up to 5 characters available to enter ID
names.
t Push [DSC] to program and to exit
the ID programming mode.
ïï
Deleting address ID
q Push [DSC] to select the DSC menu.
w Push [Y]/[Z] to select “ADDRESS” and push [DSC].
e Push [Y]/[Z] to select ‘DEL,’ then
push [DSC].
•When no address ID is programmed, the
transceiver exits the condition automati-
cally.
r Select the desired ID name pushing
[Y]/[Z], then push [DSC].
t Push [DSC] to delete the address ID;
push an other switch to exit the con-
dition.
00_IC-M402_S.qxd 02.2.21 0:07 PM Page 16 (1,1)