Icom IC-M71

TM 10-7360-226-13&P
CONTAINERIZED KITCHEN (CK) 0013 00
TROUBLESHOOTING PROCEDURES (HAND SINK ASSEMBLY)
0013 00-2
Table 1. Troubleshooting procedures (Hand Sink Assembly) - Continued
Malfunction Test or Inspection Corrective Action
Notify unit maintenance
No hot water Water heater plugged in Check/plug in water heater
(appliance control box)
Water heater switch ON (appliance
control box)
Turn water heater switch ON
Appliance control box plugged in Plug in appliance control box
Water heater circuit breaker open
(appliance control box)
Check/reset water heater circuit
breaker (appliance control box)
Appliance control box receptacle
circuit breaker closed
Check/reset appliance control
box circuit breaker (#24 on
Power Distribution Panel)
Open hot water faucet to purge
air and wait 30 minutes for
water in tank to heat
Notify unit maintenance
Water is still cold after
30 minutes
Water heater switch ON (appliance
control box)
Turn water heater switch ON
Water heater circuit breaker open
(appliance control box)
Check/reset water heater circuit
breaker (appliance control box)
Notify unit maintenance
Water is too hot Notify unit maintenance to
adjust thermostat
Sink drains slowly or
does not drain
Check sink trap for clogging.
Check drain hoses for kinks,
obstructions
Unclog sink trap. Remove
kinks or obstructions in drain
hoses
No soap from
dispenser
Check soap level in dispenser Refill soap dispenser
END OF WORK PACKAGE