Icom IC-M71

TM 10-7360-226-13&P
CONTAINERIZED KITCHEN (CK) 0013 00
TROUBLESHOOTING PROCEDURES (HAND SINK ASSEMBLY)
0013 00-1
THIS WORK PACKAGE COVERS:
Hand Sink Assembly
INITIAL SETUP:
CK set up
Maintenance Level
Operator/Crew
HAND SINK ASSEMBLY MALFUNCTIONS
Table 1. Troubleshooting Procedures (Hand Sink Assembly)
Malfunction Test or Inspection Corrective Action
No hot or cold water Water pump running Immediately turn water heater
OFF (appliance control box)
Check hoses for kinks,
obstructions, leaks, missing
washers
Remove kinks, tighten loose or
leaking fittings, repair/replace
damaged hose
Supply valve from tank trailer open Check/open valve
Notify unit maintenance
Pump will not run Immediately turn water heater
OFF (appliance control box)
Check/plug in pump power cord
Verify pump switch is ON
(appliance control box)
Verify appliance control box is
plugged in
Check/reset pump circuit
breaker (appliance control box)
Check/reset appliance control
box circuit breaker (#24 on
Power Distribution Panel)
Notify unit maintenance
Low water pressure Check hoses for kinks,
obstructions, leaks, missing
washers
Remove kinks, tighten loose or
leaking fittings, replace
damaged hose
Supply valve from tank trailer open Check/open valve