Icom IC-M71 - Page 190

TM 10-7360-226-13&P
CONTAINERIZED KITCHEN (CK) 0032 00
MAINTENANCE ALLOCATION CHART (MAC)
0032 00-9/10 Blank
TOOLS AND TEST EQUIPMENT FOR CK
Table 2. Tools and Test Equipment for CK.
TOOL OR TEST
EQUIPMENT
REFERENCE CODE
MAINTENANCE
LEVEL
NOMENCLATURE
NATIONAL STOCK
NUMBER
TOOL NUMBER
1 O
TOOL KIT, GENERAL
MECHANIC’S (GMTK)
5180-01-454-3787
2 F
SHOP EQUIPMENT,
WELDING
4940-01-090-1231
REMARKS FOR CK
Table 3. Remarks for CK.
REMARKS CODE REMARKS
A General hardware repair at O level (tighten/replace hardware, straighten piece parts)
B Washer replacement at O level
C Cable/connector repair, replacement at O level
D Caster replacement, connector repair, door gasket replacement at O level
E Power cord replacement, motor replacement at O level
F Replacement of power cord, module, caster, temperature controller at O level
G Drain cock replacement at O level
H Ballast replacement, wiring repair at O level
I Replacement of caster, towel dispenser, soap dispenser at O level
J Replacement of power cord, water heater at O level
K Replacement of power cord, water pump at O level
L Hot, cold faucet washer replacement, faucet replacement at O level
M Switch replacement at O level
N Circuit breaker replacement at O level
O PC board replacement at O level
P Converter replacement at O level
Q Fabric repair at O level
R Winch, cable replacement at O level
S Drain repair, sink replacement at O level
T Fuel line section replacement at O level
U Rivet repair at DS level
V Welding repair at DS level
W Shear pin replacement at O level
X Temperature control module replacement at O level
Y Power connector, ground terminal, contactor replacement at O level
Z Cam-lock replacement at O level