TM 10-7360-226-13&P
CONTAINERIZED KITCHEN (CK) 0006 00
OPERATION UNDER USUAL CONDITIONS
0006 00-4
EXTENSION/
BASE PLATE
JACK BODY
Figure 2. Corner Jack Installation.
CAUTION
When raising the container, the two corner jacks MUST be operated
together. Raising one jack alone can result in damage to the jacks.
10. Simultaneously rotate the two jack handles clockwise and raise the end of the container until
it is slightly higher than the opposite end. Observing the bullseye level, separately adjust
the rotation rate of the jacks as necessary to level the end of the container from side to side.
11. Install the two screw jacks next to the corner jacks, in the holes on the side of the corner
blocks. Raise the screw jacks until the operating screw is tight (cannot be turned by hand).
Remove the corner jacks.
12. Repeating step 7 above, install the corner jacks at the opposite end of the container.
Simultaneously rotate the two jack handles clockwise to raise the container. Observing the
bullseye level mounted in a recess to the left of the mechanical room doors, separately
adjust the rotation rate of the jacks as necessary to level the end of the container from side
to side. Once the end is level, raise both corners together until the container is level from
end to end.
13. Return the jack/winch handles to their storage locations on the side of the rifle rack. Strap
them in place with their handle ends up.
To Next Page
Loading...
