How to fix an Icom IC-M72 Transceiver that does not turn on?
If your Icom Transceiver won't turn on, the most likely cause is a depleted battery. Recharge the battery pack. Also, check the connection to the transceiver to ensure it is secure.
How to unlock the channel on my Icom Transceiver?
If the displayed channel on your Icom Transceiver cannot be changed, the lock function may be activated. Push [H/L•LOCK] for 1 second to cancel the function.
How to unlock my Icom IC-M72?
If the lock function is activated on your Icom Transceiver, push [H/L•LOCK] for 1 second to cancel the function.
Why is there no sound coming from my Icom IC-M72 Transceiver speaker?
If your Icom Transceiver speaker isn't producing sound, there could be several reasons: * The squelch level might be set too high; try adjusting it to the threshold point. * The volume could be too low; rotate the [VOL] knob to increase it. * If the speaker has been exposed to water, press and hold both [16•9] and [H/L•LOCK] to drain it. * If water has entered the [SP MIC] connector, make sure to dry it thoroughly.
What to do if the “CHARGE” comment blinks on my Icom IC-M72?
If your Icom Transceiver displays a blinking “CHARGE” comment, it means the connected battery is depleted and needs to be recharged.
Why can't I transmit or select high power on my Icom IC-M72?
If you can't transmit or select high power on your Icom Transceiver, it could be due to several reasons: * You may be on a channel that only supports low power or receive-only; try changing channels. * The battery might be low; recharge it. * The battery could be overcharged; verify the voltage is correct. * The output power might be set to low; push [H/L•LOCK] to select high power.
Why is my Icom Transceiver transmitting continuously with VOX enabled?
If your Icom Transceiver is transmitting continuously when using the VOX function, it could be due to loud ambient noise. Try pushing [ ] and [H/L•LOCK] to deactivate the VOX function. You can also set the VOX gain to a lower sensitivity value.
Why doesn't the scan start on my Icom IC-M72?
If your Icom Transceiver scan does not start, it may be because “TAG” channels are not programmed. Set the desired channels as “TAG” channels.
How to turn on beep sounds on an Icom IC-M72?
If your Icom Transceiver is not making any beeping sounds, the beep tones may be turned off. Go to the SET mode and set the beep tones to ON (Fix Beep/User Beep).
What does a temperature self-check error mean on my Icom Transceiver?
If your Icom Transceiver shows a self-check error related to temperature, it means the temperature is outside the range of –35°C to +73°C (approximately –31°F to +163°F). Leave the transceiver at room temperature for a while, then turn the power ON to check if the internal temperature has returned to normal.
General| Brand | Icom |
|---|---|
| Model | IC-M72 |
| Category | Transceiver |
| Language | English |
To Next Page
