Icom IC-M85 - 3 Disassembly Instruction

SECTION 3 DISASSEMBLY INSTRUCTION
3-1
1. REMOVING THE FRONT PANEL
Remove 2 knobs and antenna nut from the front 1)
panel.
Antenna nut
Dial knob
Knob
Remove with;
“ICOM Driver (K)”
(8960000112)
Remove 2 screws from the bottom of chassis.2)
Screws
Separate the chassis from the front panel.3)
Front panel
Chassis
BE CAREFUL about the flat cable when separating the
chassis from the front panel.
Suction lifter
For easy separation of the CHASSIS
Use a suction lifter to lift the bottom of the CHASSIS up.
Suction lifter
• Part name: EA950R-2
• Manufacture: ESCO CO.LTD
Disconnect the flat cable from the LOGIC UNIT, 4)
then separate the chassis from the front panel.
Front panel
Flat cable
Chassis
J1
FLAT CABLE
Lift up
flat cable