14
5
MEMORY CHANNELS
■ Memory bank selection
The receiver has 400 memory channels in 8 banks for stor-
age of often-used frequencies.
q Select memory mode with [V/M].
w Rotate [DIAL] while pushing [FUNC] to select the desired
memory banks.
•“1” – “3” indicate memory banks 1 to 3; “♦” indicates memory
bank 4; “♦1” – “♦3” indicate memory banks 5 to 7; no bank indi-
cator indicates memory bank 0.
e Rotate [DIAL] to select the desired memory channel.
■ Memory clear
Unwanted memory channels can be cleared (erased). Before
clearing a memory channel make sure it is no longer needed
as cleared memories cannot be recalled.
q Select memory mode with [V/M].
w Set the memory channel to be cleared with [DIAL].
•Rotate [DIAL] while pushing [FUNC] to select a memory bank or
programmed scan edge channel.
e Select VFO mode with [V/M] and push [FUNC] + [(V/M)MW]
momentarily to indicate the selected memory channel.
•Do not hold [FUNC] + [(V/M)MW] for more than 0.5 sec., other-
wise the selected memory channel will be overwritten.
r Push [FUNC] + [(MODE)LOCK] for 2 sec. to clear the se-
lected memory channel.
•3 beeps sound, then the frequency is cleared.
t Push [V/M] to return to VFO mode.
To Next Page
Loading...
Need help?
General
