17
6
SCAN OPERATION
■ Selecting scan edges
The scanning range can be set to all frequencies (full scan), a
selected band or between two user-programmed frequencies
(programmed scan).
The programmed scan edges can be programmed in the
same manner as programming regular memory channels.
Program the desired scan edge frequencies in a pair of
programmed scan edge channels in advance. (pgs. 12, 13)
q Select VFO mode with [V/M].
w While pushing [FUNC], push [BAND] to enter band edge
set mode.
e Rotate [DIAL] to select the desired scan edge.
•“ALL” for full scan, “BAND” for band scan or “PROG 0”–
“PROG24” for programmed scan.
r Push [BAND] to exit band edge set mode; or push [FUNC]
+ [Y] or [Z] momentarily to start the programmed scan
using the selected edges.
To Next Page
