18
6
SCAN OPERATION
■ Skip channel setting
Memory channels can be set to be skipped for memory skip
scan. In addition, memory channels can be set to be skipped
for both memory skip scan and frequency skip scan. These
are useful to speedup the scan interval.
q Select memory mode with [V/M].
w Rotate [DIAL] to select a memory channel to be pro-
grammed as a skip channel.
e While pushing [FUNC], push [
(TS)SKIP] one or more times
to select a condition.
•No indication : channel will not be skipped.
•“SKIP” appears : channel skipped during memory scan.
•“P SKIP” appears : channel skipped during memory scan; fre-
quency skipped during other scans.
The frequency skip function is effective when the fre-
quency skip function (P SCAN) is turned ON. See the next
page for details.
■ Scan resume condition
DSetting the scan pause time
The scan pauses when receiving signals according to the
scan pause time. It can be set from 2–20 sec. or unlimited.
q Push [V/M] for 2 sec. to enter expanded set mode.
w Rotate [DIAL] until “PAUSE” appears.
•Turn the expanded set mode ON for selection. (p. 25)
e
While pushing [FUNC], rotate [DIAL] to select the condition.
•“2SEC”–“20SEC”: scan pauses for 2–20 sec. on a received sig-
nal.
•“HOLD”: scan pauses on a received signal until it disappears.
r Push [V/M] to exit set mode.
DSetting the scan resume time
The scan restarts after a signal disappears according to the
resume time. It can be set from 0–5 sec. or unlimited.
q Push [V/M] for 2 sec. to enter expanded set mode.
w Rotate [DIAL] until “RESUME” appears.
•Turn the expanded set mode ON for selection. (p. 25)
e While pushing [FUNC], rotate [DIAL] to select condition.
•“1SEC”–“5SEC”: scan restarts 1–5 sec. after the signal disap-
pears.
•“0SEC”: scan restarts immediately after the signal disappears.
•“HOLD”: scan restarts by rotating [DIAL] only.
r Push [V/M] to exit set mode.
To Next Page
Loading...
Need help?
General
