Icom IC-R7000 Instruction Manual

3) Press the [PRIO] SWITCH.
r-SCAN STARTISTOP----,
~P!'I.IO ITRPROG
0
SEL-M MODE MEMORY
~~L!!.~~
~~a~~
Frequency being received
FM
--!i>
8
n
:1
n n n
0.
_I
Ll
U. Ll
SCAN
M th
-1 ,-,
c
a
4) Scan speed can be changed by the SCAN SPEED
CONTROL.
()tO~
SPEED ~DELAY
5) The scan will stop when a signal is received.
6) Press the [PRIO] SWITCH or turn the TUNING
CONTROL to cancel the scan.
7)
Press the [PR 10-SET] SWITCH to check the
PRIORITY frequency.
(2) PROGRAMMED SCAN
1) Press the [PROG-SET] SWITCH.
I
I
,---SCAN START STO"---,
~~[·~=
~~iisiiii
FM
I
-1
[
[
,-, ,-,
,-,
I
c
_I.
_I
u
U.U
~
I
M ell
I
-1
I I
"LO" lights up.
3) Press the PRIORITY SCAN START/STOP SWITCH to start the
scan.
The "SCAN" indicator will light up on the FREQUENCY DIS-
PLAY, and the PRIORITY SCAN function will begin.
PRIORITY SCAN will continue scanning even if the squelch is
left open or if the memory channel being scanned is in blank
status.
Priority frequency
q
I
FM
ld ch
l
I
Lj
n n
,-;
n n
p
-
I
.J. Ll
Ll L1.
!..1
SIG
SCAN
4) Whefl the scan is operating, scanning speed can be changed by
setting the SCAN SPEED CONTROL.
See SECTION 5-6 (3) SCAN SPEED for further details.
5) When a signal is received in the PRIORITY channel, the scan will
stop once for the time period specified by the SCAN DELAY
CONTROL and will then start again or be cancelled.
See SECTION 5-6 (2) DELAY TIME for further details.
6) Press the PRIORITY SCAN START/STOP SWITCH again or turn
the TUNING CONTROL to cancel the scan.
7) Press tne PRIORITY SCAN SET SWITCH to check a frequency
written into the PRIORITY channel.
(EXAMPLE)
Press switch
Press keys
Setting frequency 147.0000MHz in the PRI-
ORITY channel and starting PRIORITY SCAN.
[PRIO-SET]
[1] [4] [7] [ENT]
Press switch to start scan
[PRIO]
PROGRAMMED SCAN repeatedly scans frequencies set in a pro-
grammed scan range. These frequencies are stored in special
memories in the IC-R7000 for instant accessibility.
1) Press the PROGRAMMED SCAN SET SWITCH to set the lower
frequency limit (LO).
The "LO" indicator will light up on the FREQUENCY DISPLAY.
-20-

Icom IC-R7000 Specifications

General

Brand	Icom
Model	IC-R7000
Category	Receiver
Language	English