Icom IC-R7000 Instruction Manual

(4) SELECTED MODE MEMORY SCAN
1) Press the number keys and press [MEMORY CH]
CONTROL or turn [MEMORY CH] CONTROL.
2) Press the number keys or turn the TUN lNG
CONTROL.
3) Press a receive.MODE SWITCH.
Specified receive mode
I
AM
I 1-/-l[nn
,)C. 1_/Lf.L/
M ch
I -1
I I
4) Press the [ME.MORY CH-WRITE] SWITCH.
5) Press the [MODE] SWITCH.
AM
I 1_1 :1 -, [ ,-, ,-,
I I L . I _I Ll. Ll
SCAN
M :;h
I -,
I I
6) Scan speed can be changed by the [SCAN
SPEED] CONTROL.
7) Turn the [SCAN DELAY] CONTROL.
8) Press the [MODE] SWITCH or turn the TUNING
CONTROL.
• SELECTED MODE MEMORY
SCAN NOTES
SELECTED MODE MEMORY SCAN repeatedly scans specified
receive
modes of frequencies stored in the memory channels.
1) Press the number keys on the KEYBOARD and press the
[MEMORY CH] SELECTOR CONTROL or turn the [MEMORY
CH] SELECTOR CONTROL to choose a memory channel.
See SECTION 5-4 for further details on selecting a memory
channel.
2) Press the number keys or turn the TUNING CONTROL to set a
frequency for storage.
3) Press one of the four receive MODE SWITCHES to select a
receive
mode.
4) Press the [MEMORY CH-WRITE] SWITCH to enter the desired
frequency and mode information into the selected memory
channel.
See page 5 for more information regarding use of the [MEMORY
CH-WRITE] SWITCH.
NOTE: At least two memory channels must be set in order for
SELECTED MODE MEMORY SCAN to operate.
Follow the same procedures above to enter a second frequency
with the same receive mode into a memory chan~el.
5) Press the MODE SCAN START/STOP SWITCH to activate the
scan.
AM M th
1 -, r ,-, ,-, r ,-,
, :t :t. u u :t. u c
1
B
SCAN
r-----1'',
' )
L-----•.,/
6) When the scan is operating, scanning speed can be changed by
turning the SCAN SPEED CONTROL.
7) Turn the SCAN DELAY CONTROL to the appropriate setting to
stop and delay the received signal.
See page 28 regarding use of the SCAN DELAY CONTROL.
8) Press the MODE SCAN START/STOP SWITCH again, or turn the
TUNING CONTROL to cancel the scan.
• The scan should not be started in a blank status memory, as it will
then scan only memories in blank status.
• Scanning will be cancelled if the newly selected mode is not
contained in the memory channels.
-24-

Icom IC-R7000 Specifications

General

Brand	Icom
Model	IC-R7000
Category	Receiver
Language	English