Icom IC-R7000 Instruction Manual

4) Press the [MEMORY] SCAN SWITCH.
I
I
r----o SCAN START/SlOP -----,
~PROO ~PO\OG n SEL-M MOOE MEMORY
~~l~.~~
~~~~~
AM
1 1nnnnn
I I J. Ll Ll Ll. L1
s;AN
"SCAN" lights up.
M ch
f 5
5) Scan speed can be changed by turning the
[SCAN-SPEED] CONTROL.
6) Turn the [SCAN DELAY] CONTROL.
7) Press the [MEMORY] SWITCH or turn the
TUNING CONTROL.
(6) AUTO-WRITE MEMORY SCAN
1) Press the [PROG-SET] SWITCH.
r---SCAN STAAT,STOP--,
~~[~.~~
[aEa][aEa]Ea]
2) Press number keys and [ ENT] key to set the
lower frequency limit.
• Lower frequency limit
SSB M <h
I
I n n n n
I
8
n
I I
LI.LI
Ll Ll.
I
u
tO
•
"LO" lights up.
4) Press the MEMORY SCAN START/STOP SWITCH to activate
the scan.
The "SCAN" indicator will light up on the FREQUENCY
DISPLAY.
5) When the scan is operating, scanning speed can be changed by
setting the SCAN SPEED CONTROL.
6) Turn the SCAN DELAY CONTROL to the desired setting to
delay the incoming signal.
See page 28 for more information regarding use of the SCAN
DELAY CONTROL.
7) Press the MEMORY SCAN START/STOP SWITCH or turn the
TUNING CONTROL to cancel the scan.
• While the scan is operating, all memory channels except those in
blank status will be scanned.
(EXAMPLE)
Choose memory channels and enter frequencies
as in SELECTED MEMORY SCAN (pages
22 ~ 23).
After entering frequencies and receive modes
into memory channels:
Press switch to start scan
[MEMORY]
AUTO-WRITE MEMORY SCAN repeatedly scans frequencies set in
the PROGRAMMED scan range. Each time a signal is received its
frequency is automatically written into memory channels 80
through 99.
1) Press the PROGRAMMED SCAN SET SWITCH to set the lower
frequency limit in the programmed scan range (LO).
The "LO" indicator will light up on the FREQUENCY DISPLAY.
See SECTION 5-4 for programming frequencies into memory
channels.
2) Press appropriate number keys and [ENT] key on the KEY-
BOARD to program the desired lower frequency limit.
The FREQUENCY DISPLAY will automatically shift to the "HI"
indicator once the lower frequency number is entered.
Follow the same procedure as specified in SECTION 5-3 F RE-
QUENCY SETTING.
-26-

Icom IC-R7000 Specifications

General

Brand	Icom
Model	IC-R7000
Category	Receiver
Language	English