37
BASIC MANUAL
10
MAINTENANCE
■ Resetting
Occasionally, erroneous information is displayed when, for example, rst applying power.
This may be caused externally by static electricity or by other factors.
If this problem occurs, perform a Partial reset or an All reset.
BE CAREFUL! An All reset clears all programming and returns all settings to the factory
defaults. See the Advanced manual for details.
After performing an All reset, you cannot use the DR function because the Repeater List
contents are also cleared.
D Partial Reset
[MENU] > SET > Others > Reset > Partial Reset
1. Push [MENU].
2. Select “Others” in the “SET” menu.
3. Select “Reset.”
4. Select “Partial Reset.”
• The conrmation dialog is displayed.
5. Select “YES.”
• “PARTIAL RESET” is displayed, and then the display automatically returns to the default
screen.
TIP: A Partial Reset resets the operating settings to their defaults without clearing the
following:
• Memory Channel contents • Call Channel contents • Radio Memory contents
• Scan Edge contents • Message data • GPS memory contents
• Call sign memories • DTMF memory contents • Repeater list
• Bluetooth pairing list • Opening picture
To Next Page
Loading...
