Icom ID-52A

10
MAINTENANCE
39
BASIC MANUAL
■ Troubleshooting
L “AM” indicates the PDF type Advanced Manual.
PROBLEM POSSIBLE CAUSE SOLUTION REF.
Transmitting is
impossible.
The transmit power level is
set to S-Low, Low1, Low2,
or Mid.
Set the transmit power level
to High.
p. 20
The PTT Lock function is
activated.
Turn OFF the PTT Lock
function on the MENU
screen.
p. 73
The Busy Lockout function
is activated.
Turn OFF the Busy Lockout
function on the MENU
screen.
p. 73
The transmit frequency is
out of the amateur radio
band.
Set the transmit frequency
within the amateur radio
band.
p. 19
A Program Scan does
not start.
The VFO mode is not
selected.
Push [VFO/MHz] to select
the VFO mode.
p. 14
The same frequencies are
entered into the scan edges.
Enter di󰀨erent frequencies
into the scan edges.
AM
A Memory Scan does
not start.
The Memory mode is not
selected.
Push [MR] to select the
Memory mode.
p. 14
Only one or no memory
channel is entered.
Enter two or more memory
channels.
p. 23
A distorted noise
is heard when the
earphone is used.
The earphone mode is OFF. Turn ON the earphone mode
on the MENU screen.
p. 74
Charging is impossible
at power ON.
“Charging (Power ON)” is
set to “OFF.”
Set “Charging (Power ON)”
to “ON” (default) on the
MENU screen.*
p. 73
* This operation may generate certain spurious signals, the S-meter appears, or noise may be
heard.