84
<<<<<<<<<Automation>>>>>>>>>>
Ease creating and managing automation is a highlight of using a control surface with motor faders.
Press the Automation buttons to change the automation behavior of the selected track.
Automation Modes:
Read = Toggle between Read and Off:
Set to Read, the channel will respond to existing automation in real time. Any parameters with
automation will jump to existing automated values during playback.
Set to Off, the channel will ignore all automation.
Write = All channel parameters record automation during playback. This overrides and replaces all
automation. This is for tracking an unassisted mixdown performance.
Touch = The channel reads existing automation, plus writes automation for specic parameters
adjusted during playback. This only creates automation while parameters are being edited.
Latch = Reads existing automation, plus writes automation for specic parameters adjusted during
playback. This continues to write automation for any parameters which have been changed during
playback.
Trim = Trim allows automation to be modied instead of overwritten. Adjusting knobs and faders
during playback will make a change relative to existing automation.
Off= Disable track automation. Set to Off, the channel will ignore all automation.
Plug-In Assignment:
Plug-In = Select a channel, then press Plug-In. Next press Plug-In Assign to view the selected
channel’s inserts 1-4 on the LCD Display.Turn the Encoder Knobs to add/select plug-in effects.
Press Plug-In Assign to conrm. Turn Encoder Knob 5 to access insert 5 on knob 1. Press an
Encoder Knob 1-4 to edit the selected plugin. Parametersappear on the LCD Display above track
1-4. Turn the Encoder Knobs to edit the lower parameter, press the Encoder Knobs to toggle
the upper parameter. Turn Encoder Knob 5 to access further pages of parameters on knobs 1-4.
Press Encoder Knob 5 to return to viewing inserts for the selected channel.
While a plugin is open:
Bypass = Toggle Plug-In Bypass
Compare = Toggle previous plugin parameter settings
Send Assignment:
Assign + Send A-E = Activates Send Routing, edit send destination for each track with the
Encoder Knobs. Press Assign to conrm.
Send A-E = Activates Send Assignment, Turn the Encoder Knobs to adjust the send level to the
corresponding send destination for eachtrack.
Press Flip to access the currentSend Faders on themotor faders.
To Next Page
Loading...
Need help?
General
