MACH+ heat recovery units— User and installer manual
© Ideal Clima-page 3 of 20
The user and maintenance manual should be used as follows:
- each operator and personnel involved in the use and maintenance of the unit must read this manual in
full and with the utmost care and respect what is stated;
- the employer must ensure that the operator meets the requirements for the operation of the unit and has
carefully read the manual; the employer must also inform the operator thoroughly of the accident risks
and in particular of the risks arising from noise, personal protective equipment and General Accident
rules laid down by international laws or standards and of the country of destination of the unit;
- the manual must always be available to the user, the managers, the persons in charge of the transport,
installation, use, maintenance, repair and final dismantling;
- store the manual in areas protected from moisture and heat and consider it an integral part of the unit
for its entire duration, handing it over to any other user or subsequent owner of the unit;
Pay close attention to the following symbols. Their function is to highlight particular information such as:
In relation to serious dangerous situations that may occur with the use of the unit to ensure the
safety of persons.
In reference to dangerous situations that may occur with the use of the unit to avoid damage to
things and the unit itself.
With reference to additions or suggestions for the correct use of the unit.
The manufacturer shall have the right to modify the production and its manuals, without the obligation to
update previous versions, except in special cases.
This manual reflects the state of the art at the time of sale of the unit and cannot be considered inadequate
only because it has subsequently updated on the basis of new technologies.
1.1 LIABILITY
The unit is guaranteed according to the contractual agreements entered into at the sale.
The manufacturer is deemed exempt from all liability and obligation, and the form of warranty provided by the
sales contract for any accident to persons or things that may occur due to:
- failure to comply with the instructions in this manual with regard to the operation, use,
maintenance and events in any case unrelated to the normal and correct use of the unit
- modifications made to the unit and safety devices without prior written authorization from the
manufacturer;
- repair attempts carried out on their own or by unauthorised technicians;
- no regular and constant maintenance or use of non-original spare parts.
In any case, if the user attributed the accident to a defect of the unit, he must prove that the damage
occurred was a main and direct consequence of such “defect”.
1.2 SERVICE STANDARDS
The service standards described in this manual are an integral part of the delivery of the unit.
These rules are also intended for the operator already specifically instructed to operate this type of unit and
contain all the information necessary and essential for the safety of operation and optimal use of the unit.
To Next Page
Loading...
