To Next PageTo Next Page
Need help?Do you have a question about the IDEAL Logic and is the answer not in the manual?
General| Refrigerant | R32 |
|---|---|
| Type | Air Source |
| Operating Temperature Range (Heating) | -20°C |
| Seasonal Coefficient of Performance (SCOP) | 3.8 - 4.5 |
| Noise Level | 50-60 dB(A) (depending on model) |
Hazards associated with R32 refrigerant and precautions to avoid ignition sources.
Prohibits modification and stresses adherence to installation requirements.
Emphasizes the need for qualified service engineers for maintenance.
Stresses operating the product as outlined in manuals.
Details power supply requirements, earthing, and risks of electrical work.
Proper disposal methods for product waste and refrigerant.
Warns about condensate freezing and potential slipping hazards.
Guidelines for use by children or persons with reduced capabilities.
Instructions for cleaning the heat pump casing, control box, and DHW cylinder.
Recommends annual servicing by a competent heat pump engineer.
Describes the four main components of the refrigerant circuit: Evaporator, Compressor, Condenser, Expansion Device.
How the heat pump heats DHW, prioritizing over space heating.
How the heat pump provides space heating based on thermostat demand.
Automatic weekly DHW heating to 60°C for legionella prevention.
Explains the automatic defrost process and condensate drainage.
Covers cold start procedures and appliance, condenser, dwelling frost protection.
Explains how weather compensation optimises flow temperatures based on ambient conditions.
Explains how to navigate the controller using the dial.
Shows and explains the main display screen elements and data shown.
Explains the meaning of various status symbols on the controller.
Explains common navigation icons used in the controller interface.
Lists and describes the different operating modes and indicators.
How to initiate space heating or hot water demands using the controller.
Step-by-step guide to setting the daily heating schedule for zones.
Step-by-step guide to setting the system's time and date.
How to access special operations like Emergency Mode via the settings menu.
Instructions on how to enable the DHW immersion heater via the controller.
Guide on how to adjust the desired temperature setpoints for heating zones.
How to identify and view active faults displayed on the controller screen.
Details specific error codes and their descriptions for fault diagnosis.
Step-by-step guide to diagnose and resolve no hot water issues.
Step-by-step guide to diagnose and resolve no space heating issues.
Step-by-step guide to diagnose and resolve space heating temperature too high issues.
Step-by-step guide for diagnosing issues with both heating and hot water.
