To Next PageTo Next PageTo Previous PageTo Previous Page
What to do if there is no hot water from my IDEAL Logic+ SYSTEM 15 Boiler?
To address the issue of no hot water with your IDEAL Boiler: * First, ensure that the mains power is on and that the control knob (B) is correctly positioned. * Next, verify that the boiler program is set to the 'ON' position and that the water cylinder thermostat is adequately turned up.
General| Model | Logic+ SYSTEM 15 |
|---|---|
| Category | Boiler |
| Output Rating | 15 kW |
| ErP Rating | A |
| Fuel Type | Natural Gas |
| Dimensions (H x W x D) | 700 x 395 x 278 mm |
| Type | System Boiler |
| Mounting | Wall Mounted |
| ERP Heating Efficiency | 93% |
| Standard Warranty | 7 Years |
Visual guide to boiler components for installation.
Steps for unpacking the boiler and its accessories.
Instructions for correctly installing the flue through a wall.
Guidelines for safe and compliant electrical hookup.
Procedures for final checks and system setup.
Recommended frequency and tasks for annual maintenance.
Procedure for accessing internal boiler components.
Steps for cleaning a key component for efficiency.
Guide for replacing the main circuit board.
Overview of diagnostic codes and troubleshooting steps.
Specific fault code diagnosis and resolution.
Diagnosis and resolution for flame loss errors.
Overview of the boiler's features and operation.
Crucial safety information and regulations for users.
How to start, operate, and control the boiler.
Guidance for users to identify issues before calling for service.
