5
Preface
Safety Precautions
Note: If the equipment is used in a manner other than specified, the protection provided by the
equipment may be impaired.
The analyzer does not contain any user-serviceable components. DO NOT disassemble.
Line voltage for the Catalyst One AC power adapter is 100–240 V AC, 50–60 Hz. Be sure to plug all
equipment into properly grounded electrical outlets.
Use only the AC power adapter and AC power cable supplied.
Disconnect the AC power cable from the wall outlet if the:
• AC power cable or the DC power cord becomes frayed or otherwise damaged.
• AC power adapter is exposed to water or other liquids.
Performance Precaution
Do not use certain liquids, aerosols (such as canned air), solvents, ammonia, and other substances
on or near the analyzer which could influence results.
Care of the Analyzer
It is recommended that you do not stack other equipment or containers on top of the analyzer.
Keep analyzer away from sources of heat or flames.
PROTECT your equipment from damp conditions, wet weather, or liquid spills.
Take care not to spill water or other liquids on the unit.
DO NOT use solvents, ink markers, sprays containing volatile liquids, or polish on the analyzer as it
may damage the outer case. Clean only with a mild soap and slightly moist cloth and only when the
analyzer is not in use.
Clean only with a mild soap and slightly moist cloth and only when the analyzer is not in use.
To Next Page
Loading...
Need help?
General
