Idis DR-2204P - Page 53

Part 2 - Conguration
53
Video Loss
● Actions: Specify which actions to take when a Video
Loss event occurs.
– Record: Specify which cameras to begin linked
recording on when an event occurs. If the schedule
is set to Event or Time & Event mode, the selected
cameras will begin linked recording when an event
occurs.
– Alarm-Out: Designate event-triggered alarm-out
channels (each for the NVR and camera) and beeps.
– Notify: Congure to be notied of events by Mail,
LAN1 through 5, SNS, Push, and/or Alert Window.
– EventUpload: Uploads the video clips when an
event occurs.
– PTZ: Moves the PTZ camera to a specic preset
position when an event occurs.
– Event Monitoring: Selects the cameras to monitor
when an event occurs.
In order to use the Callback feature, the NVR must be
registered on the remote program.
– Ignoring Interval: The system does not produce
event log entries or issue remote notications for
video loss detected for the time specied after
the initial video loss was detected. Set the value
between 0.1 and 15 seconds or choose Never.
This is supported only when video encoders are
connected.
● Use Ignoring Time: Select Time Setup to specify
the time to ignore video loss detection. Video loss
detection will be disabled for a specied time period.
This is supported only when video encoders are
connected.
Audio Detection
● No.: Select which cameras to apply Audio Detection
to.
● Sensitivity: Set to between 1 (Low) and 5 (High).
● Activation Time: Specify how long audio detection
has to last in order for it to be considered an event.
Audio detections that do not last for the specied
duration of time will not be considered as events.
● Actions: Specify which actions to take when audio
detection events occur.
– Record: Specify which cameras to begin linked
recording on when an event occurs. If the schedule
is set to Event or Time & Event mode, the selected
cameras will begin linked recording when an event
occurs.
– Alarm-Out: Designate event-triggered alarm-out
channels (each for the NVR and camera) and beeps.
– Notify: Congure to be notied of events by Mail,
LAN1 through 5, SNS, Push, and/or Alert Window.
– EventUpload: Uploads the video clips when an
event occurs.
– PTZ: Moves the PTZ camera to a specic preset
position when an event occurs.
– Event Monitoring: Selects the cameras to monitor
when an event occurs.
In order to use the Callback feature, the NVR must be
registered on the remote program.
● Ignoring Interval: The system does not produce
event log entries or issues remote notications
regarding audio detected during the specied time
following the initial audio detection. Set a value
between 1 sec and 5 secs or choose Never.
● Use Ignoring Time: Select Time Setup to specify the
audio detection ignore time. Audio detection will be
disabled during the specied time frame.