idp Solid 510 - User Manual

Cleaning the iDP Solid 510 printer
To maintain the best condition of SOLID-510 printer, you must clean the printer periodically.
Suggested cleaning after printing 1,000 badges. If you use the exclusive long cleaning card as
the picture, you can clean the printer easily.
If the exclusive long cleaning card is ready, click the “Clean Printer” in the service tab of
SOLID-510 printer driver.
Go to the Control Panel on badge laptop
- Hardware & Sound
- Devices & Printers
- Right click Solid 510 Printer and select Printer Properties
- Select the Service Tab
- Click “Clean Printer”
After clicking, the Clean Printer program will give you steps to follow to clean the printer.
Or, you can set the Cleaning Mode with LCD buttons on the front of the printer by
pushing both buttons for 5 seconds after opening the top cover.

Summary

Cleaning the iDP Solid 510 Printer

Software Cleaning Procedure

Initiate cleaning via printer driver's Service tab by following on-screen prompts and steps.

Physical Cleaning Mode

Activate cleaning mode using the printer's front LCD buttons by pressing both for 5 seconds.

idp Solid 510 Specifications

General

Print Resolution	300 dpi
Print Technology	Dye-sublimation
Connectivity	USB, Ethernet
Card Capacity	Input Hopper: 100 Cards, Output Hopper: 40 Cards
Card Thickness	0.38mm (15mil) ~ 1.0mm (40mil)
Card Size	CR80 (85.6 mm x 54 mm)
Operating System	Windows 7/8/10
Memory	32 MB
Supported Media Types	PVC
Maximum Print Width	54 mm