LOCATION 49 Low Battery Reporting Code
A low battery condition is reported when the battery voltage drops below 11.8V for a period longer than 5
minutes or immediately if it drops below 10V.
LOCATION 50 Battery Restore Reporting Code
This code is reported once the battery voltage rises above 12 volts for a period of five minutes.
LOCATION 51 Auto Test Reporting Code
This code is reported at regular intervals. See location 112, page 37.
This code is reported once successful access to the panel has been obtained.
LOCATION 53 Siren Trouble Reporting Code
This code is reported when the siren fuse blows or when the siren or siren wiring is tampered with.
LOCATION 56 Device Tamper Reporting Code
This code is reported when there is a tamper condition on any external device attached to the keypad
bus.
LOCATION 57 Keypad Bus Failure Reporting Code
This code is reported when there is a fault on the keypad bus
LOCATION 58 Box Tamper Reporting Code
This code is reported when the box tamper contacts are open for a period exceeding 200 ms.
LOCATION 59 Dedicated Panic Reporting Code
This code is reported when the dedicated panic zone is violated.
LOCATION 60 Phone Line Restoral Reporting Code
If phone line monitoring is enabled (Location 38), this code is reported once phone line integrity has been
restored to indicate that the phone line has been tampered with.
LOCATION 61 RF Jamming Reporting Code
This reporting code will be reported if a jamming signal is detected by the RF receiver module for a
period exceeding 30 seconds.
LOCATION 62 RF Jamming Restore Reporting Code
This reporting code will be reported once the jamming signal has ceased for a period exceeding 30
seconds.
To Next Page
Loading...
