IDS 1632 Installer Manual 700-256-02K Issued September 2009
NOTES ON CONTACT ID / SIA
If the panel has been programmed to use the Contact ID or SIA format, it will not be necessary to
program individual reporting codes. Provision is made to enable/disable the reporting of certain groups
of codes. See location 118 to120. Table 10 contains a list of standard (default) Contact ID reporting
codes. Any event that relates to a specific zone, or to a specific user, will have the relevant zone/user
number appended to the end of the Contact ID reporting code.
Table 10 : Standard Contact ID Reporting Codes
Keypad Medical 1100 Cancel 1406
Fire 1110 Open by Download 1407
Keypad Fire 1110 Open with Key-switch 1409
Panic 1120 Low Battery 1302
Panic Zone 1120 Sounder / Relay Trouble 1320
Keypad Panic 1120 Expansion Module Fail 1333
Duress 1121 Zone/ Sensor Bypass 1570
Burglary violation 1130 Zone / Sensor Bypass Restoral 3570
Interior Violation 1132 Test Report 1602
24 Hour (Safe) violation 1133 Panic Restore 3120
Entry/ Exit violation 1134 Zone Restoral 3130
Day/ night violation 1135 Keypad Tamper restore 3137
Outdoor violation 1136 Zone Restoral 3130
Tamper violation 1137 Sensor Tamper Restore 3144
Keypad Tamper 1137 Expansion Module Tamper Restore 3145
Keypad lockout 1137 RF Low Battery Restore 3384
Near Alarm Violation 1138 Close by User 3401
Tamper by Zone 1144 Close by Auto Arm 3403
Exp. Module Low Bat 1338 Close with Key-switch 3409
RF Receiver Jam Detect 1344 Expansion Module Fail Restore 3333
Long Range Transmitter Fault 1353 AC Loss 3321
Loss of Supervision RF 1381 AC Restoral 3333
RF Low Battery 1384 Low Battery Restore 3302
Open by User 1401 Sounder / Relay Restore 3320
NOTES ON DOMESTIC REPORTING:
If Dual Reporting is enabled, Domestic reporting may either be reported to 2 telephone numbers or using
the dual reporting option, report to a central station as well as to an individual mobile phone etc. This
format provides for a simple form of easily identifiable remote alarm which may be reported to an office,
mobile phone etc.
A series of tones is transmitted to the phone that notifies the user that an alarm condition has
occurred. If a 1 is programmed to a location, a single beep will be heard if that particular alarm condition
occurs. If a 2 is programmed to a location, 2 beeps will be heard etc.
Typing the user code and pressing the [#] key on the phone will terminate the reporting
process. If this is not done, the panel will keep calling that same number for the number of times stored
in location 115 (number of dial attempts).
NOTE:
If the system is armed using the quick arm key [1] the system will report a close by user 35.
To Next Page
Loading...
