IDS 1632 - Programming Telephone Numbers

IDS 1632 Installer Manual 700-256-02K Issued September 2009
43
LOCATION 120 Group Reporting Code Enable / Disable 3
LED
ON / OFF
Action
1
ON Enable RF Jamming
OFF Disable RF Jamming
2
ON Enable RF Jamming Restore
OFF Disable RF Jamming Restore
3
ON
RESERVED
OFF
4
ON
RESERVED
OFF
5
ON
RESERVED
OFF
6
ON
RESERVED
OFF
7
ON
RESERVED
OFF
8
ON
RESERVED
OFF
9
ON
RESERVED
OFF
10
ON Enable SIM PIN Error
OFF Disable SIM PIN Error
11
ON Enable GSM Modem Error
OFF Disable GSM Modem Error
11.1 Programming Telephone Numbers
For the telephone number locations a value of [0] is used as a termination digit. It is important therefore
that any zeros (0) in the telephone number itself be entered as a [10]. All hexadecimal values are entered
using the mode key (see table 2), page 18.
Enter numbers consecutively with no other key presses between each digit.
To dial a “0” program a [10] – by pressing [MODE] [0]
To dial a “*” program an [11] - by pressing [MODE] [1]
To dial a "#" program a [12] - by pressing [MODE] [2]
Inserting pauses
A pause may be inserted at any point within the telephone number: Entering a value of [13] (by pressing
[MODE] [3]) will provide a 12 second pause and a value of [15] (by pressing [MODE] [5]) will provide
a 4 second pause.
To terminate a telephone number, program a [0] immediately after the last digit of the telephone number.