IDS 1632 - Cellphone Operation Settings

IDS 1632 Installer Manual 700-256-02K Issued September 2009
45
The Call-back feature when enabled, allows the download software/PC to request that the
panel call it back using the phone number as programmed into location 125.
LOCATION 124 Number of Rings to Answer (Default = 15)
This location determines the number of rings before the panel “answers" the telephone line. In the event
that the panel answers the call and no valid download log on sequence is received within 40 seconds,
and no DTMF is entered, the panel will terminate the call.
LOCATION 125 Call-back Phone Number
If Call-back is enabled in Download Options (Location 123) the phone number programmed into this
location will be used to respond to a call-back request from the IDS Download Software/PC.
11.4 Cellphone Operation Settings
LOCATION 126
Cellphone Number Storage Sub-locations
NOTE:
Locations 126 and 127 only apply to installations fitted with the IDS GSM Module.
Sub-location 1
Airtime Number
NOTE:
Only applicable to prepaid accounts, this is the number to be dialled to establish how much Airtime
remains in the account associated with the SIM card installed in the GPRS Module)
The next five sub-locations hold the authorised cellphone numbers with which the panel will
communicate. See location 127, sub-location 2 for setting SMS command rights.
Sub-location 2 SMS User 1 Cellphone Number
Sub-location 3 SMS User 2 Cellphone Number
Sub-location 4
SMS User 3 Cellphone Number
Sub-location 5 SMS User 4 Cellphone Number
Sub-location 6 SMS User 5 Cellphone Number
LOCATION 127 PIN Code and SMS Options
Sub-location 1
SIM Card PIN Number
The SIM PIN code is stored here. Zeros are entered as zeros – NOT [MODE] [0] – as is the case with
number to be dialled. This location is only relevant if the manufacturer has set up the module to be used
with the user’s own SIM card.