IDS 1632 - 12 Partition Setup

IDS 1632 Installer Manual 700-256-02K Issued September 2009
46
Sub-location 2 Accept SMS Commands from Cellphones
(Enter a value from 0 to 5. Zero accepts SMSs from no cellphones, any other value (1 to 5) will accept
SMSs from that user's Cell Number, AND all those user numbers preceding it in the list.
Sub-location 3 PIN Error Reporting Code
This is the code to be sent when there is a PIN code error
Sub-location 4
GSM Modem Error Reporting Code
This is the code to be sent when there is a problem with the GSM Modem – and it will be sent via dial-up,
DTMF, or simplex radio, if installed.
Sub-location 5 Low Airtime Threshold
If the low airtime trouble condition is enabled (option 16 of location 40), when the airtime balance drops
below this value the trouble condition will occur. The module checks the airtime every time it dials out or
sends an SMS. This is only applicable to pay as you go SIM cards.
Sub-location 6 Cellphones to Report to
0 reports to no cellphones - any other value (1 to 5) will allow enable reporting to be sent to that user's
Cell Number, AND all those user numbers preceding it in the list.
IE: - “1" would just report to the first user, and "3", for example, would cause reports to be sent to the first
three user cell numbers.
12. Partition Setup
LOCATIONS 128 – 135 Partition Setup
Location No
Partition
Location No
Partition
128 Partition 1 132 Partition 5
129 Partition 2 133 Partition 6
130
Partition 3
134
Partition 7
131
Partition 4
135
Partition 8
Sub-location 1 Partition Zone Allocation
This location is bitmapped with each LED representing a zone.
Lit LED’S represent the zones in the selected partition. Enter the number of the zone followed by the [*]
key to select or deselect zones. By default, all zones are allocated to partition 1 and no zones are
allocated to partition 2.
Sub-location 2
Primary Account Code
This account code is used if single reporting has been enabled. If dual reporting is enabled then this
account code is reported to telephone number 1.