IDS 1632 - Page 47

IDS 1632 Installer Manual 700-256-02K Issued September 2009
47
Sub-location 3 Secondary Account Code
This account code is only used when dual reporting is enabled. It is reported to Telephone Number 2
Sub-location 4
Partition Arm Options
LED
On / Off
ACTION
1
ON Enable Instant Alarm
OFF Disable Instant Alarm
2
ON
Enable Instant Key -switch Arm
OFF Disable Instant Key-switch Arm
3
ON Enable Quick Arm Key
OFF Disable Quick Arm Key
4
ON Enable Quick Stay Arm Key
OFF Disable Quick Stay Arm Key
5
ON Enable Auto Stay Arm if No Exit Zone is Triggered
OFF Panel Away Arms regardless of Zone Triggered
6
ON
Enable Auto Stay Arm if No Exit Zone is Triggered when arming
with a key-switch (or remote)
OFF
Disable Auto Stay Arm if No Exit Zone is Triggered when arming
with a key-switch (or remote)
7
ON
Enable Forced Arm
OFF Disable Forced Arm
8
ON Enable Zone Bypassing
OFF Disable Zone Bypassing
9
ON Enable Arm with Zones in the Entry Route Violated
OFF Disable Arm with Zones in the Entry Route Violated
10
ON Enable Siren Toot on Arm
OFF Disable Siren Toot on Arm
11
ON Enable Siren Toot on Disarm
OFF
Disable Siren Toot on Disarm
12
ON
Enable the Entry Beep
OFF
Disable the Entry Beep
13
ON Enable the Exit Beep
OFF Disable the Exit Beep
14
ON Enable Engineer's Reset
OFF Disable Engineer's Reset
15
ON Enable Auto Disarm
OFF Disable Auto Disarm
Default values are shaded
Quick Arm:
This option allows the user to arm the panel by holding down the [1] key for two seconds until the keypad
beeps.
Force Arm:
With this option enabled, the panel will arm with violated zones e.g. an open window. When the panel
arms, any violated zone is bypassed. If bypassed zones restore during the arm cycle (a window is
closed, for example), the zone is automatically re-activated (un-bypassed).