IDS 1632 - Page 55

IDS 1632 Installer Manual 700-256-02K Issued September 2009
55
255 User 120 380 User 245
256 User 121 381 User 246
257 User 122 382 User 247
258 User 123 383 User 248
259 User 124 384 User 249
260
User 125
385
User 250
When the panel is defaulted, User Code 1 defaults to 1234 and is a Master User Code. All other User
Codes are erased.
Sub-location 1 Assigned to Partitions
This bitmapped sub-location determines which partition a user code is assigned to. By default, User
Code 1 is assigned to all Partitions. All other User Codes are assigned to Partition 1 only.
LED
Partition
LED
Partition
LED 1 Partition 1 LED 5 Partition 5
LED 2
Partition 2
LED 6
Partition 6
LED 3
Partition 3
LED 7
Partition 7
LED 4 Partition 4 LED 8 Partition 8
Sub-location 2 User Code Properties
This is a bitmapped sub-location.
LED
User Option
1 Master user
2 Duress code
3 Arm to disarm code (maid’s code)
4 Group Arm
5 Group Disarm
6 Arm Code
7
Disarm Code
8
Report User Open Close
9
User Phone-in Access
10 Report User Access
11 Enable Anti Pass Back for user
12 Fire Code
NOTE:
A master user code allows for the programming of other user codes in User Programming Mode.
User Reporting Codes (for 4x 2 and Domestic Reporting)
For all these locations, a two digit hexadecimal code must be programmed. To disable a reporting code
a double zero (00) must be entered into the corresponding location. Note that if one of the above
mentioned reporting digits is inadvertently omitted or programmed as a zero, the code will not be
reported. The exception to this rule is when using domestic reporting where only the first digit is used.
Sub-location 3 Close Reporting Code
This code is reported when the panel is AWAY ARMED.