IDS X Series Training V2.3 | Advanced Miscellaneous Settings
Advanced Miscellaneous Settings
Location 32: Auto Test Interval
Location Type: Standard
The time between test signals that are sent back to the monitoring company. Every time an auto test is
done the event is automatically and sequentially numbered, the counter starts at 0 and increments to 255.
Location 33: Auto Test Time
Location Type: Standard
This is the time of day that the test signal, set in location 32, must be transmitted
Data Format: hhmm
Valid Range: 0000 - 2359
Default: 0010
Location 34: Download Code Default Disable
Location Type: Standard
The download code is a security code to stop any illegal connection and changing of data via external
connections, using IDSwift software. If this option is enabled then defaulting the system will have no effect
on the download code.
Valid Range: 0 or 10
Location 35: Hardware Default Switch Disable
Location Type: Standard
Every system has a hardware default switch which is activated by removing power from the system and
powering up while holding the switch down until the status LED flashes. If this option is enabled then the
only way to default is via the installer code and location 0.
Enable defaulting of the download code
Disable the defaulting of the download code
Location 36: Zone Status Verify Time
Location Type: Standard
This is the time a zone is monitored for a restore. If the zone does not restore, the system will wait the time
entered in this location after the siren timeout before sending another burglary event after the siren has
timed out.
Data Format: mmss
Valid Range: 0001 to 5959
Default: 1000 (10 min)
Enable Download code defaulting
Disable Download code defaulting