IDS X16 User Manual

84
Alarm Memory | IDS X Series Training V2.3
Changing Partitions
This option allows a user to access different partitions on a keypad.
[Mode] [1] [*] [Partition] [*]
Note: This will only be available if the keypad is a global keypad. (Keypad Options Location 251 to
258)
Changing Stay Profiles
There are four stay profiles that can be created for different requirements, for example: When staying at
home in the evening the outside detectors can be activated while the indoor detectors are bypassed.
Then when going to bed all external and internal detectors except the bedrooms are made active by
changing the profile.
[Mode] [2] [*] [Stay Profile] [*]
Setting Outputs 1 to 5
Outputs, one to five, can be manually triggered on or off, via the keypad.
[Mode] [3] [*] [Output [*]
Alarm Memory
Alarm memory holds information on zones that triggered, tampered with and bypassed for the arm cycle
that has just been disarmed. Once the system arms again this information is cleared, ready for any new
information to store.
To access this information: press and hold [0] until the beep.
Key press
Information displayed
Explanation
Hold [0] until beep
Any zones that were
violated
All zones that triggered while the system was armed will
be displayed
Press [2] [*]
Zones that were bypassed
Any zones that were bypassed for that arm cycle
Press [3][*]
Tampered zones
All zones that were fiddled with and their tamper
monitoring circuits triggered
Press [6] [*]
Event log
Press and hold
until beep
Menu
Option
Partition
Number
Press and
hold until
beep
Stay Profile
Menu Option
Stay Profile
Number
Press and
hold until
beep
Output
triggering Menu
Option
Output Number

IDS X16 Specifications

General

Brand	IDS
Model	X16
Category	Security System
Language	English