Global Settings | IDS X Series Training V2.3
1. Programming zones using both the string and bitmapped methods.
a. Let‟s program zones 9 to 16 using the string method and zones 17 to 24 using the bitmapped sub-
locaton method
b. The table describes what type of zone each one will be
c. To program zones 9 to 16 into the system via the string method:
Type in the complete string of information for all
zones
[0][8] [0][2] [0][2] [0][4] [0][4] [1][5] [1][5] [0][3] [*]
d. Programming zones 7 and 8 using the sub-location method:
Enter the sub-location number for zone 7 and press the [*] key
Enter the value for an external instant zone followed by the [*] key.)
To exit location 1 press the [#] key
Note: You will still be installer mode
Global Settings
Location 10: Zone Shutdown Count
Location Type: Standard
This option monitors the zone for the number of times it violates when the system is armed. Once the
number of violations reaches the number entered in this location, the zone is automatically bypassed.
Each partition has an option to enable any zones belonging to the partition that were bypassed due to this
option in locations 221 to 228 depending on the partition.
Valid Range: 1 - 15
Default: 5
Location 11: Programmable Zone Loop Response Time
Location Type: Standard
This is the time that the zone must be violated before the zone will register a violation.
Valid Range: 1 - 255
Default: 2
To Next Page
Loading...
Need help?
General
