IDS X64

IDS | Wireless Hardware
13
Location 302 Global reporting
Sub Loc
Description
Explanation
1
Bus device tamper
When a device that is connected to the keypad bus registers a tamper
this code is sent to the alarm company
2
Bus device tamper restore
When the device on the bus registers that the tamper condition has
been restored it will send this code
3
Bus peripheral
Communication fail
When a device that has been registered on the bus stops
communicating the control panel will send this code to alert the
company monitoring the alarm
4
Bus peripheral
Communication restore
Once the communication between the control panel and the missing
device is corrected a restoral is sent to the alarm company
5
Bus peripheral power/battery
low
A device that has the ability to monitor its power detects that it’s power
is low a message can be sent
6
Bus peripheral power/battery
restore
Once the power is restored a signal alerting the monitoring company
can be sent
7
Wireless detector battery low
Wireless devices monitor their batteries and when a battery needs
changing this low battery code is sent
8
Wireless detector battery
restore
After changing the battery a restoral is sent
Location 303 Global reporting
Sub Loc
Description
Explanation
1
Wireless detector supervision
failure
Each device checks in with the controller at a predetermined time and if
this signal is not received, the alarm company is alerted that it has gone
missing
2
Wireless detector supervision
restore
When the wireless device starts communicating after being missing a
restoral is sent
3
Wireless receiver signal jam
If the receiver detects a signal that could block effective communication
from the devices that it is monitoring an alert is sent to the monitoring
company
4
Wireless receiver signal
restore
When the signal causing the jam has been removed a restoral is sent
5
Wireless Detector RSSI low
Each detectors signal strength is checked and if the signal strength
drops below 20% a low RSSI is sent
6
Wireless Detector RSSI
restore
Once the signal strength of a device increases above 20% a RSSI
restore is sent
7
Dedicated Panic
On board is a dedicated panic zone, when triggered this code is sent
8
Test report
The X64 can be programmed to send test signals to confirm that it is
still alive
9
Download report code
After the system has been connected to by IDSwift software a code is
sent.