IDS X64

IDS | Event Reporting
17
Location 574 Global Split Reporting
LED
On/Off
Action
Explanation
Split Reporting
Option
1
OFF
Bus device comms
restored
When a device has stopped communicating on the bus
and when the fault is corrected and communication is
restored a signal is sent to confirm this.
9 OFF
2
OFF
Bus device battery
restored
A device that reported a low battery on the bus will send
a restore when the battery voltage is full and report the
restoral condition
10 OFF
3
OFF
Wireless detector
battery restored
Once the wireless devices battery is changed it will
respond by sending a restore
11 OFF
4
OFF
Wireless detector
supervision restored
When a device starts communicating after being marked
as missing by the system a supervision restoral is sent
12 OFF
5
OFF
Wireless receiver jam
restored
After detecting a strong signal that could cause wireless
devices from communicating is switched off a restoral
will be sent
13 OFF
6
OFF
Wireless detector
RSSI low restored
A device that recorded a low signal recovers and the
signal comes up to an acceptable level a restoral will be
sent
14 OFF
7
ON
Dedicated Panic
The X64 has a dedicated panic onboard and if this is
triggered a panic signal will be sent
15 OFF
8
ON
Test Report
The alarm can be configured to send a test report every
6 hours to every 14 days
16 OFF
Options 9 to 16 are to select which split reporting telephone numbers to report too.
Off = split reporting group 1, On = split reporting group
Location 575 Global Split Reporting
LED
On/Off
Action
Explanation
Split Reporting
Option
1
OFF
IDSwift Download
Accessed
This option reports when the system has been
communicated with by the download software
9 OFF
Options 9 to 16 are to select which split reporting telephone numbers to report too.
Off = split reporting group 1, On = split reporting group