Wireless Device Hardware setup
Note: The import thing to remember is that when you have chosen the supervision time of 3Hrs on
the X64 is to make sure the detectors are also set to 90min.
The correct hardware must be used as the older Duevi wireless detectors will not learn to the
integrated receiver
Duevi Outdoor Wireless Dual Head PIR - 866-DX-OPWF
Dip switch 5: On = 24 Hrs Off = 90 min
Default: 90 minutes check in
Note: To learn the dual PIR to the X64 first get both PIR heads to detect movement then press the tamper
switch when in location 260 sub location 1 and the correct zone number has been selected
Duevi Wireless Door Contact including input - 866-DX-PWF
JP2 jumper: On = 24Hrs Off = 90min
Default: 24 hours
Note: To learn the door contact to the X64 press the tamper switch when in location 260 sub location 1 and
the correct zone number has been selected
Duevi Wireless Indoor Wireless pet tolerant (small pet) PIR - 866-DX-PWF
SPV jumper: On =24Hrs Off = 90min
Default: 24 hours
Note: To learn the indoor PIR to the X64 press the tamper switch when in location 260 sub location 1 and
the correct zone number has been selected
Duevi Outdoor E-Wall with PIR & Microwave - 866-DX-EWF
Dip switch 4: On = 24Hrs Off = 90min
Default: 90 minutes
Note: To learn the door contact to the X64 press the tamper switch when in location 260 sub location 1 and
the correct zone number has been selected
To Next Page
Loading...
Need help?
General
