The unit can be electronically locked to prevent unwanted adjustment
of the set parameters: Press both pushbuttons until is displayed.
To unlock: Press both pushbuttons until is displayed. Units are
delivered from the factory in the unlocked state.
With the unit in the locked state is indicated briefly when you try
to change parameter values.
20
Programming
1
Press the Mode/Enter button
several times until the respective
parameter is displayed.
Press the Set button and keep
it pressed. The current parameter
value flashes for 5s,
then the value is increased*
(incremental by pressing briefly or
scrolling by holding pressed).
Press the Mode/Enter button
briefly (= acknowledgement).
The parameter is displayed again,
the set parameter value
becomes effective.
2
3
4
Change more parameters:
Start again with step 1.
Finish programming:
Wait for 15s or press the
Mode/Enter button until the current
measured value is indicated again.
*Decrease the value: Let the display of the parameter value move to the
maximum setting value. Then the cycle starts again at the minimum setting
value.
Select the display unit (Uni) before setting values for the parameters SP1
and rP1. This avoids rounding errors generated internally during the conversi-
on of the units and enables exact setting of the values.
Setting at the factory: bAr.
If no button is pressed for 15s during the setting procedure, the unit returns
to the Run mode with unchanged values.
To Next Page
Loading...
Need help?
General
