IFM Ecomat 300 AC1421 - Page 59

59
ifm Device Manual SmartSPS AC14 with EtherNet/IP interface (AC1421, AC1422), Firmware 3.1.2 2015-11-30
Menu AS-i 1 / AS-i 2
>
5.3.2 AS-i 1 / AS-i 2: Diagnosis
9039
The [Diagnosis] menu provides access to the diagnostic data of the selected AS-i network.
>
Display and reset the error counters
9042
To display and reset the AS-i error counters:
1 Select the menu page
► > or >
► Select [Error counters] tab.
2 Display the error counters
> Page shows the following information:
Designation
Meaning
Telegrams
Number of message errors that occurred
Configuration
Number of configuration errors that occurred
Voltage < 22,5V
Number of voltage errors < 22.5 V
Voltage < 19,0V
Number of voltage errors < 19.0 V
Earth fault
Number of detected earth faults
3 Optional: reset the error counters
► Press [Reset] button.
> All error counters are reset to 0.
>
Display the error statistics of the AS-i slaves
9087
To display the error messages of the AS-i slaves on the selected AS-i master:
1 Select the menu page
► > or >
► Select [Errors / slave] tab.
2 Display the error statistics of the AS-i slaves
> Page shows the following information:
Column header
Meaning
Adress
Address of the AS-i slave
S/A
Number of errors of the single or A slave at this address
B
Number of errors of the B slave at this address
► Use [] / [] to scroll through the table.