IFM Ecomat 300 AC1421 - Page 66

66
ifm Device Manual SmartSPS AC14 with EtherNet/IP interface (AC1421, AC1422), Firmware 3.1.2 2015-11-30
Menu AS-i 1 / AS-i 2
>
Change the Extended ID1 of the AS-i slave
10952
To set the Extended ID1 of an AS-i slave:
1 Select the menu page
► > or >
► Select an AS-i slave (→ Slave selector (→ page 30)).
► Select [Setup] tab.
2 Set the Extended ID1
> The list [ID1] displays the current Extended ID1 value (hexadecimal format).
► Select the desired value for Extended ID1 from the list [ID1].
> Selected value is applied.
After changing the Extended ID1, the existing configuration no longer corresponds to the stored
configuration:
> An error message appears (configuration error).
► Start a projection adaptation (→ Carry out a projection adaptation (→ page 58)).