85
ifm Device Manual SmartSPS AC14 with EtherNet/IP interface (AC1421, AC1422), Firmware 3.1.2 2015-11-30
Menu System
>
Restore the device configuration
14442
Risk of undesirable system behaviour!
The AC142n is not available during the recovery process.
► Ensure by means of organisational measures that the AC142n system is in the safe state during
the recovery process!
16200
Risk of data loss and undesirable system behaviour!
If the import of the device configuration is interrupted (e.g. because the device is disconnected from
the electric circuit), not all the configuration data will saved on the device.
► Do not interrupt the recovery process!
► Ensure a stable voltage supply!
Pay attention to the notes (→ Clone device configuration (→ page 84))!
If there are more than one device configurations stored in the root directory of the SD card, then
the newest file (time stamp) will be used for the restoring process.
To transfer a stored device configuration to the device:
1 Select the menu page
► >
► Select [Configuration] tab.
2 Restore the device configuration
► Insert an SD card with the stored device configuration in the SD card slot.
► Press [Import configuration] button.
> A warning message appears.
► Use [OK] to confirm the message.
> The device configuration is loaded and saved onto the device.
The device reboots.
To Next Page
