Need help?Do you have a question about the IFM LX Series and is the answer not in the manual?
General| Brand | IFM |
|---|---|
| Model | LX Series |
| Category | Measuring Instruments |
| Language | English |
Explains the guided wave radar principle, pulse transmission, reflection, and distance measurement for level detection.
Parameters are set via the IO-Link interface, allowing configuration before or during installation.
Details the analogue output (OUT2) configuration for level measurement using current or voltage signals.
General information on the IO-Link interface, its requirements, and where to find device-specific information.
Recommends vertical installation and details minimum distances to tank walls, objects, and bottom for single probe units.
Specifies requirements for coaxial probe units, including distances and vent hole considerations.
Details minimum distances to tank walls, objects, and bottom for single probe units, including diagrams.
Explains the installation of the coaxial pipe onto the rod, including sealing, centering, and tightening procedures.
Details how to screw and tighten the rod to the unit, including recommended torque and safety notes.
To Next Page
