14
Manual settings for NBN or Fibre
1. On your connected computer or WiFi device, open your web
browser and go to http://10.1.1.1
2. Log in with the default username and password, which are
both admin.
3. The Setup Wizard should run; if not, simply click Setup Wizard
on the dashboard. Enter the following details:
WAN Interfaces: Ethernet
WAN Type: Dynamic IP Address*
*Note: South Brisbane, Places Victoria and some OptiComm
Fibre services will need WAN Type PPP over Ethernet instead.
You will also need to enter your broadband username and
password.
4. If you have iiNet Netphone (VoIP), enter your VoIP details on
the next page, otherwise click “I don’t have VoIP”. You can set
up VoIP from other providers later with the steps on page
20.
5. Click Next, and then turn to page 16 to continue with the WiFi
setup.
3
4
To Next Page
Loading...
