AmpliTube X-SPACE
Reverb Models
11
Reverb Models
SHIMMER 1
A complex shimmer that offers increasing feedback. The pitch can go from 1/4 semitone up to an octave
creating many different customizable shifting voicings.
Parameters
• TIME: controls the reverb tail length.
From 5 s to 20 s.
• PRE-DELAY: not available.
• COLOR: controls the frequency response of the reverb. At minimum the reverb gets darker, at maximum
the reverb gets brighter. Set in the middle the reverb is flat.
From -10 to +10.
• MOD: controls the amount of modulation of the reverb.
From 0% to 100%.
• MIX: controls the balance of dry and wet signal. At 0% the signal is fully dry, while at 100% the signal is
fully wet. At around 85% the dry and wet signal have the same level.
From 0% to 100%.
• SHIFT: controls the pitch of the note generated by the shimmer. It can be set to perfect pitch or fine-tuned
with 1/8 of a tone.
From -12 semitones to +12 semitones.
• SIZE: controls the dimension of the ambience from which the reverb is generated. With size set to
minimum the pitch build up is quicker, set to max the pitch build up is slower.
From 50% to 150%.
• MOD RATE: controls the rate of the reverb modulation.
From 0.1 Hz to 7 Hz.
• MODE: chooses among 3 modes.
• NO PICH: offers the shimmer characteristics without the feedback build up.
• SINGLE: the pitch of the feedback keeps building up according to the SHIFT parameter.
• DUAL: the pitch of the feedback keeps building up according to the SHIFT parameter both upwards and
downwards.
• X-MODE: engages the most possible tail length.
ON or OFF.
To Next Page
Loading...
Need help?
General
